Cleaning The Water Inlet Filter - Bosch WAX32EH0EU User Manual And Installation Instructions

Cleaning the water inlet filter

Clean the filter in the water inlet in the
event of blockages or if the water pres-
sure is too low.
Emptying the water inlet hose
In order to clean the filter, first empty
the water inlet hose.
Turn off the tap.
1.
Set the Cottons
2.
Start the programme and leave it to
3.
run for approx. 70 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
Cleaning the filter on the tap
Note: Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
Requirement: The water inlet hose is
empty.
Remove the water inlet hose from
1.
the tap.
Clean the filter with a small brush.
2.
⁠ programme.
Cleaning and servicing en
Connect the water inlet hose and
3.
check for leaks.
57