Bosch WAX32EH0EU User Manual And Installation Instructions page 61

Errors
The water is not draining.
Water is not flowing in. Deter-
gent is not being dispensed.
The spin cycle runs several
times.
The programme duration
changes during the wash
cycle.
No water is visible in the
drum.
Cause
Drain pump is blocked.
Rinse Hold ⁠ is activated.
The water outlet hose is con-
nected too high.
You have not pressed Start/
⁠ Reload .
The filter in the water inflow is
blocked.
The tap is turned off.
The water inlet hose is kinked
or jammed.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
The programme operation is
optimised electronically. This
may change the programme
duration.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
Water is below the visible
area.
Troubleshooting en
Troubleshooting
→ "Cleaning the drain pump",
▶
Page 53
Continue the programme by selecting
▶
Spin or Drain and pressing Start/
⁠ Reload .
→ "Resuming the programme when
the programme status is Rinse Hold",
Page 43
Install the water outlet hose at a max-
▶
imum height of 1 metre.
→ "Technical specifications",
Page 71
Press Start/ ⁠ Reload .
▶
Clean the water inflow filter
▶
→ Page 57.
Turn on the tap.
▶
Ensure that the water inlet hose is not
▶
kinked or jammed.
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry to-
gether in the drum. Different sized items
of laundry distribute themselves better
during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry to-
gether in the drum. Different sized items
of laundry distribute themselves better
during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
61