Lexus IS350 AWD Owner's Manual page 225

WARNING
To avoid malfunction of the camera sensor
■
Observe the following precautions.
Otherwise, the camera sensor may not operate properly, possibly leading to an acci-
dent resulting in death or serious injury.
Keep the windshield clean at all times.
●
• If the windshield is dirty or covered with an oily film, water droplets, snow, etc.,
clear the windshield.
• If a glass coating agent is applied to the windshield, it will still be necessary to use
the windshield wipers to remove water droplets, etc. from the area of the wind-
shield in front of the camera sensor.
• If the inner side of the windshield where the camera sensor is installed is dirty, con-
tact your Lexus dealer.
Do not attach objects, such as stickers, trans-
●
parent stickers, and so forth, to the outer side
of the windshield in front of the camera sensor
(shaded area in the illustration).
A: From the top of the windshield to approxi-
mately 0.4 in. (1 cm) below the bottom of the
camera sensor
B: Approximately 7.9 in. (20 cm) (Approxi-
mately 4.0 in. [10 cm] to the right and left
from the center of the camera sensor)
If the part of the windshield in front of the camera sensor is fogged up or covered with
●
condensation or ice, use the windshield defogger to remove the fog, condensation or
ice. (P. 422)
If water droplets cannot be properly removed from the area of the windshield in front
●
of the camera sensor by the windshield wipers, replace the wiper insert or wiper
blade.
If the wiper inserts or wiper blades need to be replaced, contact your Lexus dealer.
IS350 AWD/IS350/IS300 AWD/IS300_U
4-5. Using the driving support systems
225
4