Technical Data - Zanussi ZWI 71000 WA User Manual

Problem
Spinning starts late or the machine
does not spin:
The machine makes an unusual
noise:
No water is visible in the drum:
If you are unable to identify or solve the problem, contact
our service centre. Before telephoning, make a note of the
model, serial number and purchase date of your machine:
the Service Centre will require this information.

Technical data

Dimensions
Electrical connection
Water supply pressure
Level of protection against ingress of solid particles and moisture
1)
Water supply
Maximum Load
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
www.zanussi.com
The electronic unbalance detection device has cut in because the laundry is
not evenly distributed in the drum. The laundry is redistributed by reverse rota-
tion of the drum. This may happen several times before the unbalance disap-
pears and normal spinning can resume. If, after 10 minutes, the laundry is still
not evenly distributed in the drum, the machine will not spin. In this case, re-
distribute the load manually and select the spin programme.
• Redistribute the laundry.
The load is too small.
• Add more items, redistribute the load manually and then select the spinning
programme.
The machine is fitted with a type of motor which makes an unusual noise com-
pared with other traditional motors. This new motor ensures a softer start and
more even distribution of the laundry in the drum when spinning, as well as
increased stability of the machine.
Machines based on modern technology operate very economically using very
little water without affecting performance.
Width / Height / Depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Cotton
Maximum
Possible cause/Solution
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ... ... ...
60 / 85 / 54 mm
220-230 V
2000 W
10 A
50 Hz
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
IPX4
Cold water
7 kg
1000 rpm
17