Zanussi ZWI712UDWA User Manual
  1. Manuals
  2. Brands
  3. Zanussi Manuals
  4. Washer
  5. ZWI712UDWA
  6. User manual

Zanussi ZWI712UDWA User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
User Manual
GETTING
STARTED?
EASY.
ZWI712UDWA
EN User Manual
Washing Machine

Advertisement

Table of Contents
loading

Related Manuals for Zanussi ZWI712UDWA

Summary of Contents for Zanussi ZWI712UDWA

  • Page 1 User Manual GETTING STARTED? EASY. ZWI712UDWA EN User Manual Washing Machine...

  • Page 2: Safety Information

    SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.

  • Page 3: Safety Instructions

    areas for communal use in blocks of flats or in launderettes. – Do not exceed the maximum load of 7 kg (refer to the • "Programme chart" chapter). The operating water pressure at the water entry point from the • outlet connection must be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa).

  • Page 4: Electrical Connection

    Contact the Authorised Service Centre to • Make sure that there is access to the tap after ensure which accessories can be used. the installation. ELECTRICAL CONNECTION WARNING! Risk of fire and electric WARNING! Risk of injury, electric shock. shock, fire, burns or damage to the appliance.
  • Page 5 THE APPLIANCE IS EQUIPPED WITH ... UNPACKING WARNING! Use the gloves. WARNING! Remove all the packaging and the transit bolts before installing the appliance. 1. Put two polystyrene packaging elements on the floor under the appliance. WARNING! It is strongly recom- mended that this action is carries out by two persons.
  • Page 6 4. Return the appliance in vertical position and remove the socket polystyrene protection. 5. Remove the power supply cable and the drain hose from the hose holders. It is possible to see water flowing from the drain hose. This is due to the testing with water of the appli- ance in factory.

  • Page 7: Positioning And Levelling

    POSITIONING AND LEVELLING 1. Install the appliance on a flat hard floor. WARNING! Make sure that carpets do not stop the air circulation below the ap- pliance. Bring the appliance near the furniture recess before levelling it. For more de- tails, refer to paragraph "Building in".
  • Page 8 The inlet hose 1. Remove the inlet hose from inside the drum. 2. To connect the water inlet hose towards the prop- er direction and with the proper inclination, check the position of the water tap before connecting it to the back of the appliance.
  • Page 9 To a stand pipe with vent-hole Directly into a drain pipe at a height of not less than Ø 40 mm 60 cm (23.6”) and not more than 100 cm (39.3”). The end of the drain hose must always be ventilated , i.e.

  • Page 10: Preparation And Assembly Of The Cupboard Door

    If hoses run behind the appliance, make 596 mm 553 mm sure that nothing closes the small re- cess indicated with the measures 50 x 50 mm. 819 mm 50 mm 50 mm 140 mm 76 mm The appliance is also equipped with an adhesive sponge pad H that you can find inside the drum.
  • Page 11 Factory pre setting The appliance is originally pre set for the assembly of a cupboard door opening from right to left. The best solution would be to screw the upper hinge to the upper hole of the top plate and the lower hinge to the lower hole of the bottom plate.
  • Page 12 Cupboard door preparation For countersinking the door, it is recom- mended to call a professional. Align the cupboard door to the furniture correctly. Measure the distance X to fix the height of the hole to countersink the upper hinge. The centre of the hole Y should be at the same height of the stroke on the hinge support.

  • Page 13: Product Description

    Mounting the door Fix the hinges to the hinge supports on the appli- ance by means of the two supplied screws B. The hinges can be adjusted to compen- sate for possible uneven thickness of the door. Counter-magnet The appliance is pre set for a magnetic closure. For a correct closure: 1.

  • Page 14: Control Panel Description

    Plate with rubber beater Mains cable Drain pump filter Inlet hose connection Front feet for levelling the appliance Back feet for levelling the appliance Drain hose CONTROL PANEL CONTROL PANEL DESCRIPTION Inicio Diferido Limpieza/ Limpeza Máquina Temperatura Centrifug. Prelava. On/Off Centrifug.

  • Page 15: Dial And Buttons

    DISPLAY Door locked indicator. Child safety lock indicator. The digital indicator can show: • Programme duration: e. g. • Delay time: e. g. • Cycle end: • Warning code: e.g. • Temperature: • Spin speed: and no spin in- dicator DIAL AND BUTTONS INTRODUCTION Touch the button repeatedly to set the required...

  • Page 16: Child Lock

    To activate/deactivate this option , hold down are available. In some programmes the rinses are performed with more water. the Prelava. button until relevant indicator comes on/goes off. If you touch the Inicio/Pausa button, the appliance performs only the draining phase. •...

  • Page 17: Programme Chart

    PROGRAMMES PROGRAMME CHART Programme Reference Default tempera- spin speed Maximum Programme description ture Spin speed load (Type of load and soil level) Temperature range range (rpm) 1200 rpm 7 kg White cotton and coloured cotton. Normal and (1200 - heavy soil. Algod.
  • Page 18 Programme Reference Default tempera- spin speed Maximum Programme description ture Spin speed load (Type of load and soil level) Temperature range range (rpm) 1200 rpm Maintenance cycle with hot water to clean and freshen the drum and to remove residue that may cause odour. Limpieza/Limpe- For the best result use this cycle once a month.
  • Page 19 Programme Reference Default tempera- spin speed Maximum Programme description ture Spin speed load (Type of load and soil level) Temperature range range (rpm) 1200 rpm 1.5 kg Machine washable wool, hand washable wool (1200 - and other fabrics with «hand washing» care sym- Lana\Lãs 400) 40 °C...

  • Page 20: Consumption Values

    Programme ■ ■ ■ Centrif./Drenar ■ ■ ■ ■ ■ Aclarado/ Enxag. Limpieza/ ■ ■ Limpeza Má- quina ■ ■ ■ Edred. ■ ■ ■ 20 min. - 3 kg ■ ■ ■ ■ ■ ■ Sport ■ ■ ■ ■...

  • Page 21: Acoustic Signals

    Approximate Remaining Energy con- Water con- programme moisture Programmes Load (kg) sumption sumption (li- duration (kWh) tre) (minutes) Algod. 1.20 60°C Algod. 1.00 40°C Sintéticos 0.69 40°C Delicados 0.43 40°C Lana\Lãs 0.14 30°C Standard cotton programmes 0.93 Standard 60°C cotton 0.70 Standard 60°C cotton 0.55...

  • Page 22: Before First Use

    BEFORE FIRST USE 1. Make sure that the electrical power is available 4. Set and start a programme for cotton at the and the water tap is open. highest temperature without any laundry in the 2. Pour 2 litres of water into the detergent drum.

  • Page 23: Check The Position Of The Detergent Flap

    CHECK THE POSITION OF THE DETERGENT SETTING A PROGRAMME FLAP 1. Turn the programme dial to select the desired 1. Pull out the detergent dispenser until it stops. washing programme. The indicator of the Inicio/Pausa button flashes. The display shows an indicative programme duration.

  • Page 24: The Autoadjust System Load Detection

    OPENING THE DOOR - ADDING GARMENTS 1. Touch the Inicio/Pausa button to pause the appliance. The related indicator flashes. If the temperature and level of the 2. Touch the Inicio Diferido button repeatedly until water in the drum are too high and/or the display shows the desired delay time.

  • Page 25: Hints And Tips

    • You do not use the appliance for 5 minutes • You must drain the water to open the door: when no programme is running. 1. If necessary, touch the Centrifug. button to Press the button On/Off to activate the decrease the spin speed proposed by the appliance again.

  • Page 26: Care And Cleaning

    DETERGENTS AND OTHER TREATMENTS • Always start a washing programme with the maximum load of laundry allowed. • Only use detergents and other treatments • If you pre-treat the stains or use a stain remover, specially made for washing machines: set a programme with a low temperature.

  • Page 27: Cleaning The Drum

    DOOR SEAL 1. Open the drawer. Press the catch downwards as indicated in the picture and pull it out. Regularly examine the seal and remove all objects from the inner part. 2. Remove the top part of the additive CLEANING THE DRUM compartment to aid cleaning and flush it out under running warm water, to remove any Regularly examine the drum to prevent unwanted...

  • Page 28: Cleaning The Drain Pump

    without any clothes in the drum. Regularly check the drain pump filter and make sure that it is clean. Clean the drain pump if: • The appliance does not drain the water. • The drum does not turn. • The appliance makes an unusual noise because of the blockage of the drain pump.
  • Page 29 180˚ 3. Turn the filter 180 degrees in anti-clockwise direc- tion to open it, without removing. Let the water flow out. 4. When the bowl is full of water, turn the filter back and empty the container. 5. Repeat the steps 3 and 4 until the water stops to flow out.
  • Page 30 9. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter cor- rectly to prevent leakages. 10. Close the pump cover. When you drain the water with the emergency drain procedure, you must activate the drain system again: 1.

  • Page 31: Emergency Drain

    EMERGENCY DRAIN 1. Disconnect the mains plug from the mains socket. If the appliance cannot drain the water, carry out 2. Close the water tap. the same procedure, described in 'Cleaning the 3. Put the two ends of the inlet hose in a drain pump' paragraph.

  • Page 32: Possible Failures

    POSSIBLE FAILURES Problem Possible solution • Make sure that the mains plug is connected to the mains socket. • Make sure that the appliance door is closed. • Make sure that there is no damaged fuse in the fuse box. The programme does not •...

  • Page 33: Emergency Door Opening

    Problem Possible solution • Make sure that the couplings of the water hoses are tight and there is not water leakages. • Make sure that the water inlet hose and the drain hose have no There is water on the floor. damages.

  • Page 34: Technical Data

    Energy Efficiency Class A+++ Spin Speed Maximum spin speed 1151 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. PRODUCT INFORMATION SHEET IN REFERENCE TO E.U. REGULATION 1369/2017 Product Information Sheet Trade Mark ZANUSSI...
  • Page 35 Model ZWI712UDWA, PNC914580231 Rated capacity in kg Energy efficiency class A+++ Energy consumption in kWh per year, based on 220 standard wash- ing cycles for cotton programmes at 60 °C and 40 °C at full and 174.0 partial load, and the consumption of the low-power modes. Actual energy consumption will depend on how the appliance is used.

  • Page 36: Environmental Concerns

    ENVIRONMENTAL CONCERNS with the symbol with the household waste. Recycle materials with the symbol . Put the Return the product to your local recycling facility or packaging in relevant containers to recycle it. Help contact your municipal office. protect the environment and human health by recycling waste of electrical and electronic appliances.
  • Page 40 WWW.ZANUSSI.COM/SHOP...

Table of Contents