Huawei eSpace IPC 2601-P User Manual page 80

eSpace IPC 2601(5601)-P
User Guide
Step 6 Run the ./help debug close module IDcommand to disable the debug log.
For example: ./help debug close 1.
The debug log is automatically disabled 30 minutes after the debug log is enabled.
----End
Configuring the Network Port Transmission Rate
Step 1 Log in to the Linux operating system as the root user.
Step 2 Run the cd /usr/app/bin/ command.
Step 3 Run the ./help ethmode command.
The command output is displayed:
Usage: help ethmode [Speed and Duplex]
Set Eth Mode.
0
1
2
3
4
Step 4 Set the transmission rate based on site requirements.
For example, run the ./help ethmode 1 command. The network port works at 10 Mbit/s
in full duplex mode.
----End
Configuring Media Streams
Step 1 Log in to the Linux operating system as the root user.
Step 2 Run the cd /usr/app/bin/ command.
Step 3 Run the ./help setmediaopen command.
The command output is displayed:
Usage: help setmediaopen [VideoStreamType] [ProtocolType] [IPAddress]
[Port]
Set Media Stream open.
VideoStreamType:
0
1
2
ProtocolType:
0
1
2
Port:need to input even numbers.
Issue 01 (2012-10-15)
auto
10M Full
10M Half
100M Full
100M Half
Host Stream
Sub Stream One
Sub Stream Two
UDP
TCP
Multicast
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
C Appendix 3 help Command Reference
76