Flat Washer - PRx Performance Profile 90" Squat Rack with Multi-Grip Bar Manual

Attach Multi-Grip Bar and Linkage Arms
Upper Linkage Arms
1. Attach the left linkage arm by removing the 5/8" x 4" hex head bolt (#13) from the top left pull up
bar. Place the Plastic Spacer on the inside of the linkage arm and place it against the top hole of the
upright.
2. Attach linkage arm, black plastic spacer, upright and Multi-Grip Bar using the 5/8" x 4" hex head bolt,
(2) 5/8" flat washer (#11) and 5/8" Nylock Nut (#12). NOTE: DO NOT over tighten.
3. Repeat on the right side.
Lower Linkage Arms
1. Place Plastic Spacer on the inside of the bottom linkage arms, place it against the 19" hole of the
upright. Attach linkage arm, Plastic Spacer (#9) and upright using a 5/8" x 3 1/2" bolt (#14), (2) 5/8"
washer (#11) and 5/8" Nylock Nut (#12) DO NOT ATTACH THE SHOCKS.
2. Repeat on the opposite side, being sure not to over tighten.
8
13 11
11
14
9
11
11
9
(701) 566-0452
12
12