PRx Performance Profile 90" Squat Rack with Multi-Grip Bar Manual page 6

Linkage Arms to Wall Brackets
1. Place the small side of the Plastic Spacer (#9) in the straight, gas shock facing portion of unbent end
of the linkage arm (as pictured below).
2. Place the linkage arm with the Plastic Spacer (#9) facing the inside of the wall bracket "ear".
3. Attach using a 1 3/4" hex head bolt (#10) and 5/8" washer (#11) on the outside of the wall bracket
"ear" and a 5/8" washer and 5/8" Nyloc Nut (#12) on the opposite side.
4. Tighten using a 15/16" socket and 15/16" wrench.
*NOTE: DO NOT over tighten any of the pivot points. This may result in the rack feeling "stiff "
moving up and down. It should move up and down freely.
5. Repeat so all four linkage arms are attached to the wall brackets.
*NOTE: DO NOT attach the shocks to the wall brackets at this point of assembly.
6
11
10
(701) 566-0452
11
9
12