Safety Regulations; Country-Specific Standards; Commissioning And Testing; Modifications To System Design And Products - Siemens DMS8000 Installation Operation, Manual, Configuration

1 Safety regulations

1.1
1.2
1.3
Building Technologies
CPS Fire Safety
This section describes the danger levels and the relevant safety regulations applicable
to the use of the products described in this manual. Please read the following work
instructions as well as the preceding section
beginning any work.

Country-specific standards

Siemens products are developed and produced in compliance with the relevant
international and European safety standards. Should additional country-specific, and/or
local safety standards or regulations concerning project planning, installation, and/or
operation of the product(s) apply, then these standards and/or regulations must also be
taken into account, in addition to the safety regulations mentioned in the product
documentation.

Commissioning and testing

Activate security-, fire- and third party systems or devices

the person responsible.
Abide by the safety regulations of the connected sub-systems when working on

management stations. This especially applies when switching-off system
components.
Inform people before the testing of alarm devices; take the possibility of panic

reactions into account.
Inform the alarm and fault receiving stations connected to the system before

carrying out any tests.

Modifications to system design and products

Modifications to a system or to individual products may cause faults or
malfunctioning.
Please request written approval from Siemens Building Technologies, FS-DMS, and
the relevant authorities concerning intended system modifications and system
extensions.
Safety regulations
Country-specific standards
About this document
thoroughly before
only
in the presence of
1
7
A6V10097205_a_en
30.09.2016