Adjusting The Spring Tensioner; Spring Tensioner Operation - Martin DT2S Operator's Manual

Adjusting the
Spring Tensioner
Martin Engineering M3687-12/17
1. Loosen the lock nut above the spring. Repeat for both sides.
2. Turn adjusting nut (equally on both sides) until cleaner blades are lightly
touching the belt.
3. Ensure the blade position is equal across belt and blades are lightly
touching across belt width.
4. Continue turning the adjusting nut equally on both sides until the spring-
compressed length is the same as indicated in Table II.
5. Tighten the lock nuts against the adjusting nuts.
Belt Travel
6.00
(152)
4.50
(114)
7.00
(178)
10.38
(264)
Figure 4. Spring Tensioner Operation
10
Lock Nut
11.26
(286)
Adjusting Nut
Threaded Rod
®
Martin DT2S Reversing Cleaner