After Installing Belt Cleaner; Cleaner Changing Belt Line; Cleaner With Belt Support - Martin DT2S Operator's Manual

After Installing Belt Cleaner

Belt Line
Figure 6a. Cleaner Changing Belt Line
Martin Engineering M3687-12/17
1. Thoroughly wipe chute wall clean above tensioner.
2. Place Conveyor Products Warning Label (P/N 23395) on outside chute
wall visible to belt cleaner operator.
3. Additional safety labels are available from CEMA. For more information
regarding CEMA safety labels visit www.cemanet.org.
4. After belt cleaner and tensioner are installed, measure from pulley shaft
to mainframe on both operator side and far side to make sure mainframe
is parallel to pulley.
5. Measure from center point of pulley to outside edge of first and last blade
to make sure blades are centered on belt.
6. Make sure cleaner is not changing belt line (Figure 6a). If it is, install
belt support ahead of blade-to-belt contact point (Figure 6b).
Failure to remove tools from installation area and conveyor
belt before turning on energy source can cause serious injury
to personnel and damage to belt.
7. Remove all tools and fire retardant cover from installation area and
conveyor belt.
13
Belt Line
Figure 6b. Cleaner with Belt Support
WARNING
!
Martin
®
DT2S Reversing Cleaner