Locating Cleaner Centerline; Primary Belt Direction - Martin DT2S Operator's Manual

Locating Cleaner
Centerline
BELT DIRECTION
Martin Engineering M3687-12/17
3. Convert far side assembly as follows:
a. Loosen jam nut (C).
b. Remove cotter pins (F).
c. Remove threaded rod (G) and spring assembly (D) from slide
bracket (B).
d. Install jam nut (C) on opposite end of threaded rod.
e. Rotate threaded rod and spring assembly 180 degrees and install on top
of mount plate. Install threaded rod into slide bracket.
f. Install cotter pins.
1. On the return side of the belt, locate the tangent point at which the belt
leaves the head pulley. Measure a distance 2.0 in. (51 mm) and draw a line
perpendicular to the belt at this point. See Figure 2.
For installation below pressure rollers, mark the vertical line
2 in. (51 mm) from the centerline of the roller. See Figure 2.
2. This line represents the centerline of the Martin
Cleaner and the cleaner mount brackets.
2.0 in.
(51 mm)
Figure 2. Primary Belt Direction
7
NOTE
®
DT2S Reversing
2.0 in.
(51 mm)
BELT DIRECTION
Martin
®
DT2S Reversing Cleaner