Table of Contents
Advertisement
Martin Engineering M3687-12/17
Do not touch or go near conveyor belt or conveyor accessories
when conveyor belt is running. Body or clothing can get
caught and pull body into conveyor belt, causing severe injury
or death.
8. Turn on conveyor belt for 1 hour.
Before installing, servicing, or adjusting the belt cleaner, turn
off and lockout / tagout / blockout / testout all energy sources
to the conveyor and conveyor accessories according to ANSI
standards. Failure to do so could result in serious injury or
death.
9. After 1 hour of operation, turn off and lockout / tagout / blockout / testout
energy source according to ANSI standards (see "References").
10. Make sure all fasteners are tight. Tighten if necessary.
11. Inspect belt cleaner for the following:
• Wear. (A small amount of "break-in" wear may be found.)
• Material buildup. (No material between blades and return side of
conveyor belt should be found.)
12. If wear, material buildup, or some other problem exists, see
"Troubleshooting/Installation Checklist."
14
DANGER
!
DANGER
!
Martin
®
DT2S Reversing Cleaner
Advertisement
Table of Contents
