Marking Chute Cutouts; Chute Cutout Detail - Martin DT2S Operator's Manual

Tensioner Bracket Mounting Holes = 9/16 in. (14 mm) dia.
2.56
(65)
6.00
(152)
4.50
(114)
5.00
(127)
7.00
(178)
Bottom Mount Spring Tensioner
Marking Chute
Cutouts
Martin Engineering M3687-12/17
10.00
(254)
2.56
(65)
4.50
(114)
4.50
(114)
5.00
(127)
7.00
(178)
Air Tensioner
Figure 3. Chute Cutout Detail
1. Using the previously marked line as the centerline, mark the chute cutout
and mount hole locations as shown in Figure 3. Repeat on both sides of
chute, ensuring the cutouts are accurately aligned with each other.
The mount hole dimension below the belt differs for air- or
spring-tensioned models. Make sure that you are using correct
dimensions and verify cleaner position before proceeding.
8
2.47
(63)
2.75
(70)
4.50
(114)
5.00
(127)
7.00
(178)
Top Mount Spring Tensioner
8.67
(220)
NOTE
®
Martin
10.00
(254)
DT2S Reversing Cleaner