Advertisement
Connected Grid Module (CGM) WPAN-OFDM-FCC Module - Cisco IOS
Software Configuration
Removing the Module
Note: Before you install the WPAN module (or remove the module) within the host router, you must power down the router
as described in either the
Grid Router Hardware Installation
Follow these steps to remove the WPAN module from a slot in the CGR 1120 or the CGR 1240:
1.
Using a screwdriver, loosen the two captive screws on the WPAN module.
2.
Gently pull the WPAN module out of the slot.
Software Configuration
Your CGR 1000 must be running Cisco IOS Release 15.7(3)M1 (cgr1000-universalk9-bundle.SPA.157-3.M1.bin) or
greater to support the CGM WPAN-OFDM-FCC Module,
Note: Before you install the CGM-WPAN-OFDM-FCC module in your Resilient Mesh Network, please review the CGR
1000 and CGM-WPAN installation documents noted in the
At the CGR 1000, configure the CGM-WPAN-OFDM-FCC Module interface using the Sample Configuration below as a
guideline. The commands shown in bold type are new commands introduced to support the module. For syntax details,
refer to
Table 5 New CLI Interface commands for the CGM-WPAN-OFDM-FCC Module, page
Sample Configuration
configure terminal
interface wpan 2/1 <---Where 2 is the slot and 1 is the port
no ip address
ip broadcast-address 0.0.0.0
no ip route-cache
ieee154 beacon-async min-interval 10 max-interval 20 suppression-coefficient 1
ieee154 dwell window 12400 max-dwell 400
ieee154 panid 106
ieee154 phy-mode 149
ieee154 ssid edgecompute-secure
ieee154 txpower 25
rpl storing-mode
rpl dag-lifetime
rpl dio-dbl 5
rpl dio-min 16
rpl version-incr-time 120
authentication host-mode multi-auth
authentication port-control auto
ipv6 address 2046:FACE::/64
ipv6 dhcp relay destination
no ipv6 pim
Cisco 1120 Connected Grid Router Hardware Installation Guide
Guide.
2001:FACE::200
Introduction, page
2.
7
or the
Cisco 1240 Connected
8.
Advertisement
