Heidolph MR Hei-End Instruction Manual page 41

OUT_SP_1 y Enter set temperature, medium/hotplate in
°C
OUT_SP_2 y Enter set safety temperature "deltaT" in °C
OUT_SP_3 y Enter set motor speed in rpm
OUT_MODE_2 y 0 = all OFF after power return
1 = heating / stirring ON after power return
(set points are obtained)
Start heater control, activate remote –
START_1
alternating display *Remote*
START_2 Start motor, activate remote – alternating
display *Remote*
Stop heater control
STOP_1
STOP_2 Motor speed=0 MotorStop
Reset to initial state – heater off, motor off,
RESET
exits remote mode
Request status
STATUS
Write commands
General commands
Note: the keypad is disabled when
in remote mode.
39
„o"
„*"
0 = ManualMode
1 = RemoteMode Start
(START_1 OR
START_2)
2 = RemoteMode Stop
(STOP_1 AND
STOP_2)
<0 Error code in case of
fault
E