Table of Contents
Advertisement
Installation Instructions
PRE-INSTALLATION INFORMATION
Compatibility
An up-to-date list of the flat panel TV models recommended for
use with Chief's FCI and PACI interactive kits can be found at
www.chiefmfg.com/Interactive-Mounts.
panel models all have the same display requirements:
•
Rigid front panel to protect LCD from wear
•
40" to 55" LED-backlit LCD to reduce interference
with the sensor due to excessive heat
•
Bezel depth of 8mm (0.33") or less for optimal
performance in flat panel display corners.
IMPORTANT ! : The following procedure assumes that
the appropriate Chief flat panel mount (not included) has
been properly installed following instructions provided
with the mount.
FCI / PACI INSTALLATION
IMPORTANT ! : Determine depth (thickness) of flat panel
TV. If the TV is MORE than 3" in depth (76.2mm),
proceed to Step 1. If the TV is LESS than 3" in depth,
proceed to
either Complete FCI Installation or Complete
PACI Installation section, as appropriate
1.
Remove and save two button head cap screws and two
washers from back of sensor assembly (F). (See Figure 1)
(F)
2
Extender
bracket
Figure 1
2.
Remove extender bracket from back of sensor assembly
(F). (See Figure 1)
3.
Attach 3"-5" extension bracket (D) to sensor assembly (F)
using two button head cap screws and two washers
removed in Step 1. (See Figure 2)
The recommended flat
.
x 2
1
(F)
3
NOTE:
Proceed to either Complete FCI Installation or
Complete PACI Installation section, as appropriate.
Complete FCI Installation
1.
Remove TV from mount.
2.
Remove end caps from flat panel mount. (See Figure 3)
2
x 2 end caps
FCI / PACI
(D)
3
Figure 2
Example of
mount
Figure 3
x 2
7
Advertisement
Table of Contents
