Table of Contents
Advertisement
FCI / PACI
Sensor Location
NOTE:
The FCI and PACI may be mounted to the left or right
side of a flat panel screen. The green sensor light
needs to always be oriented so that it is closest to
screen.
1.
Move sensor assembly to the recommended sensor
locations noted in Table 1-1, and shown in Dimensions
drawings and (See Figure 10) and (See Figure 11).
Table 1-1: Recommended Sensor Locations
Measurement
Description
Depth
Edge of sensor to
(See Figure 10)
front of screen
Lateral
Face of sensor to
Extension
edge of screen
(See Figure 11)
Sensor
assembly (F)
Edge of
sensor
Depth
dimension
0.50"
[12.7mm]
(Side view)
Figure 10
10
Operational
Recommended
Range
0" - 1"
1/2"
>3"
3"
Flat panel TV
Depth may
be adjusted
along slot
Front of
TV screen
Recommended depth
Lateral extension
dimension
3"
[76.2mm]
Face of
sensor
Sensor
assembly (F)
140°
COVERAGE
ANGLE
(Front view)
(FCI shown as example)
Figure 11
2.
The Chief interactive sensor may act differently in different
environmental settings. If placing the sensor assembly in
the recommended locations does not allow the interactive
kit to work properly, proceed to Troubleshooting section.
Troubleshooting
1.
Fully extend FCI/PACI in both lateral and depth directions
so that sensor assembly is as far as possible from the flat
panel TV.
2.
Recalibrate the eBeam software.
a. Right click on the eBeam icon on the system tray.
(See Figure 12)
b. Select Calibrate Interactive Area and follow
calibration instructions. (See Figure 12)
2b
Figure 12
Installation Instructions
Edge of flat
panel TV screen
Recommended
lateral extension
Advertisement
Table of Contents
