Step 2: Configure The Terminal; Parameters That Need To Be Set; Steps To Set The Parameters - Hypercom M4230 Manual

Step 2: Configure the Terminal

These are the parameters that need to be set.
Parameter
GPRS Network Access
Provider Name
GPRS Network User Name
GPRS Network Password
Here are the steps to set the parameters
To set the terminal GPRS configuration:
1. Press Home and then the Function key to enter Maintenance mode. A password may be required.
Type the maintenance password, then press Enter. (The default maintenance password is 028510.)
2. Press 3 to access the terminal maintenance features.
3. Press 1 to access the terminal settings.
4. Press 2 to access the GSM/GPRS configuration selections.
5. Press 1 to set the GPRS configuration.
6. Press 3 to enter the name of the GPRS network access provider.
7. Type telargo.t-mobile.com
8. Press 4 to enter the GPRS network user name and login.
9. Type HCOM then press Enter.
10. Press 5 to set the network password.
11. Type HC38 then press Enter.
12. Press Home to save the changes.
13. When prompted to save the changes, select Yes, then press Enter.
14. The screen indicates that a save is in progress.
15. Press any key to restart the terminal. The terminal will reboot and return to the terminal desktop.
Definition/Function
The network name of the GPRS access provider
The user name to access the service.
The password used to access the service.
then press Enter. (dot and dash are both under the 1key)