Diagram 5; Diagram 6; Diagram 7 - RC Factory Clik Evo Building Instructions

1,5x200mm, their location fixed by the slots in the fuselage and the
holes near the wing leading edge. The leg-fuselage intersection is
reinforced by the parts No. 6 from the plywood frame. The leg-axe joint
is part 7 of the plywood frame. Make sure that the geometry of the axes in
relation to the airframe is correct.

Diagram 5:

Now is the time to make the fuselage bracing. Cut your carbon sticks into
pieces as per the parts list and sharpen one end of each. The position of
the braces is marked by little holes in the fuselage, backbone and
horizontal stabilizer. All these carbon braces come in pairs (left –
right). Install the braces, begin at the butterfly and proceed to the
back of the airframe. Install both parts of a pair at once, always
controlling that the fuselage is square to the wing plane.
Always try a dry fit of each brace stick and only glue (little drop of CA)
them when satisfied.
Lastly glue the EPP triangular part into the front of the fuselage.

Diagram 6:

Now take the whole assembly from the workbench, turn it around and stand
it on the landing gear. Take the upper fuselage part and dry fit it into
the backbone slots. If it fits well, remove it and check, whether the
servo locations (marked by dotted lines cut into depron) suit well your
servo size and your preferred servo locations. If yes, cut through the
dotted line or customize the opening to the size of your servos. Glue
„ "
the EPP canopy to the fuselage (contact glue or CA). Glue the upper
fuselage to the assembly. Install the remaining braces
horizontal and vertical stabilizers. Make sure that the upper fuselage
is square to the horizontal plane. Install the EPP triangular part to
the front of the fuselage.
Glue the control horn (part 3 on the plywood frame) into the rudder.
Make sure that the holes in the horn are symetrically distant from the
hinge line!
Use clear adhesive tape to attach the rudder to the vertical stabilizer.
Smear little contact glue first, this way the tape will hold very well.
Proceed in the same way with the elevator.

Diagram 7:

Install the Side Force Generators (SFG's) and the lift tabs as per the
Diagram. Install the wheel pants holders (part 8 on the plywood frame)
and the wheel pants (make sure that they do not touch ground when the
model stands on the wheels). Make sure that you don't glue the wheels to
their axes!
Glue the small airbrakes to the elevator.
–
between the
„ "