Now You Can Start Building; Diagram 1; Diagram 2; Diagram 3 - RC Factory Clik Evo Building Instructions

Please check the completeness of your kit by comparing it to the
attached parts list. In case of questions or complaints, feel free to
contact us: info@rc-factory.cz .

Now you can start building:

Diagram 1:

Use sharp knife to cut the bevel to wing and aileron parts where the
aileron is hinged. Remember, the hinge is a clear adhesive tape on the
top of the wing. Repeat for the elevator and the rudder (on both parts of
fuselage, upper and lower). Use clear tape to attach the ailerons to the
wings. You may want to first prime the surfaces under the tape with a
thin smear of contact glue. Glue the 100mm carbon strip into the
–
elevator (using CA) on a straight workbench.

Diagram 2:

„ "
On your workbench, join the wings with the longest part of the backbone
„ "
and the horizontal stabilizer ( fixed part of the elevator ). All should
„ "
be bottom side up . The shape of each wing root is different,
preventing wrong assembly with the backbone. Now you may also glue
control horns into the ailerons (CA).
Glue the 3x0.5x660 mm CA strip to the leading edge of the wing,
throughout, across the curved front part of the backbone (UHUPor). Do it
on a straigt workbench, using good amount of glue. Attach (glue) the
front part of the backbone (the triangles graphic is supposed to be on
the upper side of the part). Glue the lift tabs to the front part of the
wing. Attach the EPP parts to the fuselage (CA or UHUPor). The little tab
should make sure that you do it in the right way. Check that the
thrustline is pointed to the right (left when your assembly is now
bottom side up).

Diagram 3:

Sharpen one end of the 30mm, 1.5mm diameter carbon stick. Pierce it into
the fuselage bottom part as per Diagram, leaving cca 2 mm free. CA glue
in. Now you can glue the bottom part of the fuselage to the existing
assembly.

Diagram 4:

„ "
Glue the butterfly (part 4 on the plywood frame) onto the carbon rod on
the bottom fuselage. Take 4 carbon sticks 1x250 mm and locate them into
the wing and the butterfly. Shorten the sticks as necessary. Now put
some weights over the wing and backbone, to secure them flat and
straight. Make sure that the fuselage is perfectly square to the wing
plane and glue the sticks on one side. Glue sticks on the other side and
also install the depron supports. The sticks (spars) should be
perfectly straight.
Install the landing gear as per Diagram. The gear legs are made of carbon