Beko WRE 6532 ZWBW User Manual page 43

In order to clean the dirty filter and discharge the water:
1 Unplug the machine to cut off the supply power.
A
WARNING:
Temperature of the water inside the machine may rise up to 90 ºC. To avoid burning risk, clean
the filter after the water in the machine cools down.
container is full, block the inlet of the hose by replacing the plug. After the container is emptied, repeat
the above procedure to drain the water in the machine completely.
c When draining of water is finished, close the end by the plug again and fix the hose in its place.
d Turn the pump filter to take it out.
4 Clean any residues inside the filter as well as fibers, if any, around the pump impeller region.
5 Install the filter.
6 If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If it is one piece, seat
the tabs in the lower part into their places first, and then press the upper part to close.
43 / EN
2 Open the filter cap.
3 Some of our products have emergency draining
hose and some does not have. Follow the steps
below to discharge the water.
Discharging the water when the product has an
emergency draining hose:
a Pull the emergency draining hose out from its
seat
b Place a large container at the end of the hose.
Drain the water into the container by pulling out
the plug at the end of the hose. When the
Discharging the water when the product does not
have an emergency draining hose:
a Place a large container in front of the filter to
catch water from the filter.
b Loosen pump filter (anticlockwise) until water
starts to flow. Fill the flowing water into the
container you have placed in front of the filter.
Always keep a piece of cloth handy to absorb any
spilled water.
c When the water inside the machine is finished,
take out the filter completely by turning it.
Washing Machine / User's Manual