Safety; Safety Instructions; Liability; Warranty - Mastervolt EasyView 5 Manual

6
EasyView 5 - User and Installation Manual
2

Safety

Safety instructions

2.1
WARNING!
Read the safety instructions before connecting and using the EasyView 5.
• Use the EasyView 5 following the instructions and specifications stated in this manual.
• Only use the EasyView 5 in a technical correct condition.
• Do not connect the EasyView 5 to any other network than the MasterBus network.
• Do not work on an electrical system if it is still connected to a current source. Only allow changes
in your electrical system to be carried out by qualified electricians.

Liability

2.2
Mastervolt can accept no liability for:
• Consequential damage resulting from the use of the EasyView 5.
• Possible errors in the included manual and the consequences of these.
• Use that is inconsistent with the purpose of the product.

Warranty

2.3
Mastervolt assures a two-year warranty on the EasyView 5 after purchase, on the condition that the
product is installed and used according to the instructions in this manual.
Installation or use not according to these instructions may result in under performance, damage or
failure of the product and may void this warranty. The warranty is limited to the cost of repair and/or
replacement of the product. Costs for labor or shipping are not covered by this warranty.

Disclaimer

2.4
Our products are subject to continual development and improvement. Therefore, additions or modifi-
cations to the products may cause changes to the technical data and functional specifications. No
rights can be derived from this document. Please consult our most current Terms & Conditions of
Sale.

Correct disposal of this product

2.5
This product is designed and manufactured with high quality materials and components,
which can be recycled and reused. Dispose of according to WEEE. Act according to
your local rules and do not dispose of your old products with your normal household
waste. The correct disposal of your old product will help prevent potential negative
consequences to the environment and human health.

Identification label

2.6
The identification label is located at the back
side of the EasyView 5. Important information
required for service and maintenance can be
derived from the identification label.
Never remove the identification label! Warranty void when label is removed!
Figure 1: Identification label