Eaton VCPW-HD Instruction Booklet page 12

Instruction Booklet IB131024EN
Effective November 2017
Figure 40. Remote operator plugged into its receptacle and the
selector switch in the "Close" position.
14. On the remote operator, depress "Close" button momentarily.
The 38 kV SEG&TD will charge and close automatically (see
Figure 41). Note that the device has self-sealing capability and
does not require a "Close" button to be depressed until 38 kV
SEG&TD is closed. (The incoming feeder is grounded.)
Figure 41. Depressing the "Close" button momentarily on the
remote operator.
15. Insert key "KU" into Lock #1 and rotate to release key "KB" .
This electrically disables the 38 kV SEG&TD (see Figure 42).
16. Insert key "KB" into Lock #4 and rotate key "KD" to release
and store in Utility Box. This mechanically locks the
38 kV SEG&TD in the "Close" condition. (38kV SEG&T device
cannot be opened (see Figure 42).
Noticee: At this point the 38kV SEG&TD has "Grounded the
Incoming Feeder" .
Key captured in - at end of 3.3 Step 16
Key
outside
SEOG&TD KK # 1 KK # 2
KD KU KC
12
EATON www.eaton.com
Selector
switch
KK # 3 KK # 4 KK # 5
No key KB No key CLOSE
38 kV Type VCPW-HD Simple Electrical
Ground & Test Device (SEG&TD) lower
Figure 42. Key "KU" in Lock #1 and key "KB" in Lock #1.
3.4 Un-grounding the incoming feeder
Key Key captured in- at end of 3/3 Ste[ 16
outside
SEOG&TD KK # 1 KK # 2
KD KU KC
1. Selector Switch is in the "OFF" position. Keys should be in the
positions from Step 3.3.16.
2. Obtain key "KD" from the Utility lockbox.
3. Insert key "KD" into Lock #4. Release key "KB" and place into
Lock #1. This electrically enables the 38 kV SEG&TD.
4. Release key "KU" and place into Utility Box.
5. Make sure the selector switch is in the "Off"' position (see
Figure 38).
N otee: The selector switch handle may appear slightly different ("T" or "L "
shape) however; both operate the same way.
Key captured in
Key
outside
SEOG&TD KK # 1 KK # 2
KU KB KC
6. Insert the remote operator connector into the receptacle in the
front of the 38 kV SEG&TD (Figure 39).
7 . Rotate the selector switch to the "Open"' position (Figure 7).
8. On the remote operator, momentarily depress the "Open" but-
ton (Figure 54). The 38 kV SEG&TD will open.
Key captured in
Key
outside
SEOG&TD KK # 1 KK # 2
KU KB KC
terminal instruction booklet
Selector
switch
KK # 3 KK # 4 KK # 5
No key KB No key CLOSE
Selector
switch
KK # 3 KK # 4 KK # 5
No key KD No key
Selector
switch
KK # 3 KK # 4 KK # 5
No key KD No key
OFF
OPEN