Optional Radios; Overview; Adf/Dme Tuning Window - Garmin G1000 Series Pilot's Manual

3.4 OPTIONAL RADIOS

OVERVIEW

Optionally, the G1000 system can support up to two
(2) remotely-mounted Becker RA 3502 ADF receivers and
up to two (2) remotely-mounted Honeywell KN 63 DME
transceivers.
• The Becker RA 3502 ADF receiver operates in the
190.0 kHz to 1799.5 kHz frequency band with 0.5
kHz channel spacing.
• The Honeywell KN 63 is a 200-channel, 100-watt,
all-solid-state digital DME transceiver that provides
distance information to the G1000 system.

ADF/DME TUNING WINDOW

Tuning of the ADF and DME radios is performed via
the ADF/DME Tuning window. The ADF/DME Tuning
window is an Auxiliary window that is located to the right
of the HSI on the PFD. Pressing the ADF/DME softkey
transfers the ADF/DME Tuning window ON and OFF.
NOTE: Depending upon the nature of the optional
NAV radios installed, the Radio Tuning window
is entitled either 'ADF TUNING', 'DME TUNING',
or 'ADF/DME TUNING', and its associated softkey
is entitled either 'ADF', 'DME', or 'ADF/DME',
respectively.
NOTE: When another Auxiliary window is turned
on, the ADF/DME Tuning window is removed from
the PFD.
190-00592-00 Rev. A
DME Tuning window:
Active ADF Frequency
ADF
Mode
DME
Mode
cursor through the various editable fields (i.e., standby
ADF frequency, ADF receiver mode, ADF radio volume
and DME tuning mode), while pressing the FMS knob
activates/deactivates the selection cursor in the ADF/DME
Tuning window.
Garmin G1000 Pilot's Guide for the Diamond DA40
The following information is displayed in the ADF/
• Active and standby ADF frequencies
• ADF receiver mode
• ADF receiver volume
• DME tuning mode
Figure 3-18 ADF/DME Tuning Window
Turning the large FMS knob moves the selection
NOTE: When the ADF/DME Tuning window is
turned on (i.e., displayed), the selection cursor
is automatically activated in the window and is
displayed over the standby ADF frequency field.
NAV/COM
Standby ADF Frequency
ADF
Volume
3-9