Fuel Page - Garmin G1000 Series Pilot's Manual

FUEL PAGE

The Fuel Page is accessible by pressing the FUEL soft-
key. All readouts for this page are digital and are separated
into two categories: Fuel and Fuel Calculations. Beneath
the tachometer are readouts for the fuel flow, fuel quantity
and fuel temperature.
The fuel calculation portion of the Fuel Page is based
on the fuel flow totalizer and displays the following:
• GAL REM – Current fuel remaining in gallons as
set by the pilot and adjusted for fuel burn since
last set.
• GAL USED – Quantity of fuel used in gallons.
• ENDUR – Flight time remaining with fuel
onboard (HH:MM when more than an hour
remains).
• RANGE NM – Aircraft range in nautical miles.
Fuel calculations do not use the aircraft fuel quantity
indicators and are calculated from the last time the fuel
was reset.
If desired, the pilot can utilize the DEC FUEL, INC
FUEL and RST FUEL softkeys to adjust the amount of
fuel remaining for totalizer calculations.
The second-level softkeys are available by pressing the
FUEL softkey:
• DEC FUEL – Decreases totalizer based fuel quan-
tity remaining in one-gallon increments
• INC FUEL – Increases totalizer based fuel quan-
tity remaining in one-gallon increments
• RST FUEL – Resets totalizer-based fuel quantity
remaining relative to the aircraft fuel capacity and
sets the GAL USED display to zero
190-00592-00 Rev. A Garmin G1000 Pilot's Guide for the Diamond DA40
ENGINE INDICATION SYSTEM
To decrease/increase fuel totalizer quantity:
From the System Page, press the DEC FUEL/
INC FUELsoftkey to obtain the desired number
of gallons remaining.
To reset the fuel totalizer:
From the System Page, press the RST FUEL soft-
key. This also resets the GAL USED to zero.
Engine Load
Indicator
Fuel Flow
Indicator
Fuel
Temperature
Indicator
Gallons
Used
Range in
Nautical
Miles
Figure 6-8 FUEL Page (DA40D)
Tachometer
Fuel
Quantity
Indicator
Gallons
Remaining
Endurance
6-11