Parent Unit - Philips SKM7489NC/00 User Manual

Preparing your baby monitor
EN
8
Battery operated use
1 Open the battery compartment by turning the cover (A-12)
to the left (1 OPEN), using the palm of your hand.
Take the cover off.
2 Insert four 1.5V AA batteries, noting the + and –
configuration inside the battery compartment (batteries are
not supplied; we recommend Philips alkaline batteries).
3 Put the battery compartment cover (A-12) back in place.
Close the compartment by turning the cover (A-12) to the
right (CLOSE 2), using the palm of your hand.
Note:When the units are switched off, in case of battery
operated use, the batteries will still discharge slowly.
The baby unit is now ready for battery operated use!

Parent unit

1 Open the battery compartment by sliding the cover (B-12)
downwards.
2 Insert the two 1.2V AAA size NiMH rechargeable batteries
(supplied), noting the + and – configuration inside the battery
compartment.
3 Put the battery compartment cover (B-12) back in place.
Close the compartment by sliding the cover (B-12) upward
until it clicks into position.
4 Connect the AC power adapter (B-14) of the charging base
(B-15) to a wall outlet.