Digital Equipment VT18X Upgrade And System Test Manual page 33

VT18X UPGRADE KIT INSTALLATION
T+
()T18}; Version 2.1 28-JUN-82
CoPynght 1882 DIgital E"uip,,(ent Corp
Press A. B. C. D. S. or T
A Start
S~'stef'(
(drlue A)
B Start SYster'l (dril.le B)
C Start S~'stef'l (drIue C)
D Start S"stefll (drlue D)
S Execute Self-test
T E n t e r Terr'llnal Mode
MR-7880
Figure 2-26 VT 180 Start-Up Message
The drive select red light on the front of the top (or only) disk unit should come on. This is disk
drive A. The 1/0 switch for each disk unit should light up.
NOTE: If these power indications do not occur, refer to Table 5-1 to find and correct the problem.
Continue with the system test procedure in Chapter 4.
NOTE: To turn the system's power off, simply set the 1/0 switch on the top disk drive to O.
27