Vt180 Cable Connections With One Disk Unit - Digital Equipment VT18X Upgrade And System Test Manual

VT 18X UPGRADE KIT INSTALLATION
4. Attach the BC26K terminal-to-disk cable to the disk drive port on the back of the terminal.
Attach the other end to the left connector (as viewed from the back) of the bottom (or only)
disk unit. See Figures 2-21 and 2-22.
5. If you have two dual disk units, attach the BC26Z, 20 cm (8 in) disk-to-disk I/O cable from the
right connector on the bottom disk unit (drives C and D) to the left connector on the top disk
unit (drives A and B).
6. Find the ac line cord previously removed from the video terminal and attach this ac line cord
to the ac input of the top (or only) disk unit (Figures 2-21 and 2-22). Do not plug the other end
of this cable into an ac wall receptacle at this time.
7. If you have two disk units, plug the end of a coiled line cord with prongs into the ac output of
the top disk unit and plug the end without prongs into the ac input of the bottom disk unit.
8. Plug the end of a coiled line cord with prongs into the ac output of the bottom (or only) disk
unit; plug the end without prongs into the ac input of the video terminal.
RX180
BC26K CABLE
LINE CORD
(17-00150-01 )
LIN E CORD
117-00083-09, 115 V; 17-00083-10,230 V)
MR-7252
Figure 2-21 VT180 Cable Connections with One Disk Unit
23