Advertisement
CONNECTING TRANSFORMERS
Note: Stop and make sure the supplied power supply is 277VAC rated
with any primary voltage supply greater than 120.
Attach Qwik Boxes to available support member.
1.
Attach power supplies inside of Qwik Boxes.
2.
3.
Install strain relief for low voltage wire.
4.
Drill 1/2" hole through the fascia. A conduit fitting can be installed so that conduit can be
used.
5.
Insert low voltage wire into the hole and connect to LED. Fill hole with silicone sealant.
Note: Three 106.5" Street Wrap™ Border per 60W
Power Supply.
Side by side mounting location show below can
reduce primary and secondary wiring labor time.
Primary 120VAC (IN)
VERY IMPORTANT: KEEP LOW VOLTAGE CIRCUITS ELECTRICALLY SEPARATE, DO NOT CONNECT TRANSFORMERS OR LEDs FROM
DIFFERENT 106.5" STREET WRAPS™ TOGETHER OR CONNECT MORE THAN THREE 106.5" STREET WRAPS™ TO A 60W POWER SUPPLY!
Secondary 12VDC
Low Voltage (OUT)
DO NOT
CONNECT 120
VOLTS TO LEDs.
Fascia
LEDs ARE
12VDC ONLY!
SEC. 7
Connect
Black and White
wires from
to120VAC
Connect
and
Low Voltage
wires from
Transformers
to LEDs
Power Cable
12VDC
Strain Relief
Low
Fitting
Voltage
7
Advertisement
