Advertisement
INSTALLING STREET WRAP™ INTO MOUNTING BRACKETS SEC. 2
1.
Connect wires from one section to another using red butt splice wire connectors. No more
than 45 modules in a series.
Butt Splice Wire Connector
2.
Before hanging sections that have the power cable placed between them, cut a small notch
with dikes or other tool in the back of both housing sections to allow room for cable.
NOTCH
3.
Lay the section being added on the mounting brackets. After making wire connections tuck
the wires and connectors BEHIND LED modules. Caulk notch.
4.
Insert the top edge into the top bracket latch. Push the track housing in and roll top track
housing into mounting bracket bottom point. See Figure 1.
5.
Bring Street Wrap™ sections close together by pushing sections together until LED modules
come together, but leave a 3/16" approximate expansion gap between plastic track sections.
Leave no gaps in the LEDs.
6.
Install an End Cap at the beginning and end of runs with silicone. Silicone on top side only, so
water will drain out.
7.
Finish by sliding a Coupling Rain Shield under the mounting bracket latch, over both sections.
Use a small amount of silicone on one side of rain shield to hold on.
8.
Use a small screw driver to gently pry up the Mounting Bracket Latch to insert Rain Shield
under latch making certain it is firmly attached.
3/16" Approx. expansion gap
between plastic track sections
NOT LEDs.
WIRE HOLE
BRACKET
Coupling
Rain Shield
Rain Shield
Insert top, Bracket Latch
Raised
Portion
Roll into bottom
point of track
housing
DO NOT HIT LENS TO INSTALL TRACK!
This will permanently damage the lens.
Caulk Under
Rain Shield
Caulk Top
& Corners End Caps
Fascia
Mounting
Screw
Figure 1
2
Advertisement
