Advertisement
STREET WRAP™ MOUNTING BRACKET LAYOUT
END OF A RUN
EQ.
SHARED BRACKET
3"
EQ.
END OF RUN
1. Use a chalk line, gauge, laser level, or other means to be certain the run is straight, marking locations for
brackets.
2.
Border/perimeter of sign cabinets should always have orientation of Street Fighter Wrap™ housing raised
lip outboard on vertical or diagonal. Orient brackets so that the drain holes will be on the bottom side of
the horizontal runs.
3.
Install mounting brackets. Spacing will be no greater than 17.75". Length for Standard, Mix-n-Match and
Specialty Street Wrap™ is 106.5", RGB is 104". Use pre-drilled wire hole mounting brackets at transformer
locations.
Note: Track sections share a bracket at the ends to keep ends together and straight. There must be a space left between 106.5" plastic track sections (NOT LEDs) of 3/16".
TIP
Install end bracket after housing
has been installed into previous
brackets by sliding over end to
ensure bracket is centered
between sections. Place mounting
brackets 3" on center from corners.
EQ.
EQ.
EQ.
EQ.
NOTE: MAXIMUM 3 UNITS PER 6OW POWER SUPPLY
"
EQ.
EQ.
Note: This is correct bracket orientation.
120 VAC
60W Power Supply
319.5"
106.5"
SEC. 1
EQ.
EQ.
SHARED BRACKET
EQ.
EQ.
SHARED BRACKET
Lens
Rain
Shield
182.52
3.38
LEDs
182.52
3.38
1
1
Advertisement
