Advertisement
GETTING STARTED
Following these few simple steps will ensure a successful installation each time.
Read all instructions, before starting installation.
1.
Inspect the boxes for damage and check the parts against the supplied parts list.
Note: Report damaged parts or shortages immediately to prevent job slowdown /stoppage to place of
purchase.
2.
Refer to attached provided print and confirm job measurements.
3.
Layout your job on paper, making note of Power Supply placement. Power Supplies can be placed
at the end of runs or side by side to power allowable linear footage in each direction.
Note: If job measurements do not correspond to provided drawing, call Principal LED immediately at
325-227-4577. Remember: No more than 90 modules per 60W Power Supply.
COMPONENT IDENTIFICATION & REQUIRED TOOLS
MATERIALS
Housing
Lens (LED Tube)
Mounting Clip
Profile Dimensions w/ Mounting Clips
STREET WRAP™
The LEDs come pre-installed in the 106.5" System.
ST
STREET FIGHTER RGB™
S S T
STREET FIGHTER COLORS™
PVC, UC and impact resistant
Polypropylene, UV and impact resistant
Steel
Street Wrap 1.38" X 1.69"
MOUNTING
BRACKET
WIRE HOLE
BRACKET
PLTC
CABLE
LED TRACK
STREET FIGHTER™
Rain
Shield
Tube
1.38"
ELECTRICAL
LEDs
1.69"
Input
Maximum Load
Current at Max. Load
REQUIRED TOOLS
ANGLE BRACKET
CORNER PIECE
ENDCAP
LED TUBE
RAINSHIELD
COUPLING
QWIK BOX™
CONTENTS
Street Wrap Mounting Bracket Layout...........................................1
Installing Street Wrap into Mounting Brackets...........................2
How to Wire RGB Street Wrap............................................................3
Custom Cut to Fit End of Runs & Corners......................................4
Mounting Street Wrap on an Incline...............................................5
Frame Border Installation....................................................................6
Connecting Power Supplies...............................................................7
Testing Each Section.............................................................................8
LED SPECIFICATIONS
W/mod
W/ft
LM/ft
RED
0.65
2.197
182.52
GREEN
0.65
2.197
182.52
Same for Blue, RGB and White. Numbers are based on a 60W Power Supply.
12VDC
60W OR 120W
5A
• 25' Measuring Tape
• 100' Measuring Tape Framing Square
• Square -1'
• Portable Rechargable Drill
-5/16" hexbit and unibit
-Masonry bits (If brick wall)
• Extension Cord
• Sawzall or Compound Saw Carpenter Pencil
• Caulk Gun
• Box Knife
• Wire Strippers
• Wire Snips
• Laser Tool or Chalk Line Substitute Fasteners for the Application if Applicable
Mod/ft
3.38
3.38
Advertisement
