Configuring the hardware and networks
3.2 Editing the symbols in HW Config
3.2.4
How to Edit the Symbols for the Digital Output Module
Introduction
In order to assign names to the addresses of the "DO8x24 VDC/2A" digital output module,
assign symbolic names and comments for each address in the "Edit Symbols" dialog box.
The procedure is the same as for the analog input module.
Please enter the symbolic names and comments as shown in the figure below.
Requirements
● The digital output module has been configured in HW Config.
● HW Config is open.
Result
18
First Steps (V7.1)
Getting Started, 03/2009, A5E02122181-01