How To Edit The Symbols For The Digital Output Module - Siemens SIMATIC PCS 7 Getting Started

Result
3.2.4

How to Edit the Symbols for the Digital Output Module

Introduction
To allocate names to the addresses of the "DO8xDC24V/0.5A" digital output module, assign
symbolic names and comments for each address in the "Edit Symbols" dialog.
The procedure is the same as for the analog input module.
Enter the symbolic names and comments as illustrated in the figure below.
Requirements
● The digital output module is configured in HW Config.
● HW Config is open.
Getting Started (V8.1 with APL)
Getting Started, 07/2014, A5E32713210-AA
Configuring the hardware and networks
3.2 Editing the symbols in HW Config
19