Configuring the hardware and networks
3.2 Editing the symbols in HW Config
3.2.2
How to Edit the Symbols of the Analog Output Module
Introduction
In order to assign names to the addresses of the analog output module "AO2x12Bit", assign
symbolic names and comments for each address in the "Edit Symbols" dialog box.
The procedure is the same as for the analog input module.
Please enter the symbolic names and comments as shown in the figure below.
Requirements
● The analog output module has been configured in HW Config.
● HW Config is open.
Result
16
First Steps (V7.1)
Getting Started, 03/2009, A5E02122181-01