5. Pressure Click™ Board Schematic
VCC-3.3V
R1
2K2
LD1
VCC-3.3V
AN
PWM
RST
INT
CS
CS
TX
SCK
SCK
RX
SDO
SCL
MISO
SDI
SDA
MOSI
+3.3V
+5V
GND
GND
MIKROBUS DEVICE CONN.
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specification and information contained in the present schematic are subject to change at any time without notice. Copyright © 2013 MikroElektronika. All rights reserved.
VCC-3.3V
I2C/SPI
J2
SCL
SCL/SCK
SCK
I2C/SPI
J4
SDA
SDA/SDI
SDI
I2C/SPI
VCC-3.3V
J1
INT
I2C/CS
CS
I2C/SPI
SCL
SDA
J3
SAO/SDO
SDO
VCC-3.3V
ADD1
ADD0
J5
INT
VCC-3.3V
VCC-3.3V
C1
C2
100nF
10uF
VCC-3.3V
U1
LPS331AP
VDD_IO
GND
NC
GND
NC
INT1
SCL/SCK
SCL/SPC
GND
GND
INT2
SDA/SDI
SAO/SDO
I2C/CS
6. SMD Jumpers
The Pressure Click™ board
communicates with the main
board microcontroller via I
SPI interface depending on the
position of the J1, J2, J3 and J4
SMD jumpers. These jumpers are soldered in
I
C interface position by default. There is an
2
VCC-3.3V
option to select the alternate address with
jumper J5 in the case of I
position is logic 1).
C3
100nF
7. Code Examples
Once you have done all the necessary
preparations, it's time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our
website. Just download them and you are
ready to start.
R5 27
8. Support
MikroElektronika offers
(www.mikroe.com/esupport)
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
C or
2
2
C interface (default
Libstock
.com
Free Tech Support
until the
Need help?
Do you have a question about the Pressure click and is the answer not in the manual?