Installation - Monoprice Blackbird 21614 User Manual

INSTALLATION

Perform the following steps to install this splitter into your home theater system.
1. Ensure that all equipment to be connected is powered off and unplugged from its
power source.
2. Place or mount the splitter in its intended location.
3. Using a High Speed HDMI® Cable (not included), plug one end into the HDMI input
on your display, then plug the other end into the OUT port on the splitter.
4. Using a High Speed HDMI Cable (not included), plug one end into one of the IN
ports on the splitter, then plug the other end into the HDMI output on your video
source device. Repeat for up to three additional video source devices.
5. Plug the Micro USB connector on the included AC power adapter into the FW/DC
5V port on the splitter, then plug the adapter into a nearby AC power outlet. The
POWER LED will illuminate red.
6. Plug in and power on the display.
7. Plug in and power on your HDMI video source devices. Start playback of video
content. The INPUT LED corresponding to the selected input illuminates green,
while the remaining INPUT LEDs illuminate orange.
8. Cycle through the connected inputs to verify that there is video on the display for
each source device.
Congratulations, your splitter is properly installed and ready for use!
9