Xerox XC811 Manual page 6

Safety Notes
• YOUR COPIER is equipped with an energy saving device to conserve
power when the machine is not in use. The copier may be left on
continuously.
• DO NOT allow anything to rest on the power cord. Do not locate the
copier where persons will step on the cord.
• IF AN EXTENSION CORD is used with this copier, ensure that the total
of the ampere ratings of the products plugged into the extension cord
does not exceed the extension cord ampere rating. Also, make sure
that the total amperage of all products plugged into the wall outlet does
not exceed the outlet protection.
• SLOTS AND OPENINGS in the cabinet and in the back and bottom of
the copier are provided for ventilation. To ensure reliable operation of
the copier and to protect it from overheating, these openings must not
be blocked or covered. The copier should never be placed near or
over a radiator or heat register. This copier should not be placed in a
built-in installation unless proper ventilation is provided.
• NEVER push objects of any kind into the slots of the copier as they
may touch dangerous voltage points or short out parts that could result
in a risk of fire or electric shock.
• NEVER spill liquid of any kind on the copier.
• NEVER remove any covers or guards that require a tool for removal.
There are no casual operator serviceable areas within these covers.
• NEVER defeat interlock switches. Copiers are designed to not allow
operator access to unsafe areas. Covers, guards, and interlock
switches are provided to ensure that the machine will not operate with
covers opened.
• NEVER put your hands into the fuser area just inside the Exit Tray
area. This area is hot and could produce burns.
• AVOID direct viewing of the document lights. The lamps are bright
and, while not harmful, they may cause an annoying after image. It is
recommended that the Document Cover be kept closed.
• WARNING: In order to allow this equipment to operate in proximity to
Industrial, Scientific and Medical (ISM) equipment, the external
radiation from ISM equipment may have to be limited or special
mitigation measures taken.
iv