Advertisement
- Press until the pressure limiter can be heard or the pressing dies meet.
- Pressing the front operating button takes the pressure off the system and piston travels
back (fully or partially, to directly carry out a second compression action).
4. Removing and inserting the battery
Hold the tool firmly and press the battery release button to remove the battery.
ATTENTION:
Never short-circuit the battery.
Inserting the battery
Insert the battery until it clicks into place. Make sure the poles are facing the right way.
Charging
Before using the tool, charge the battery as follows:
Connect the cable of the charger to a socket (AC). As soon as the
charger is connected to the power supply, the red LED will light up.
Inserting the battery into the charger
Insert the battery firmly, as shown in Figure 2 shown here,
until it touches the bottom of the charging compartment.
ATTENTION:
If the battery is inserted incorrectly (Figure 1),
it will not only not be charged, it may also damage the charger
(e.g. by bending the terminals/short-circuiting).
Charging
When you insert a battery into the charger, the battery will start charging
and the green control light will also light up.
When the battery is fully charged the green control light will flash.
If the yellow control light comes on, the battery is overheating. Remove the battery immediately
and disconnect the charger from the power supply.
Illustration 1
Illustration 2
Advertisement
