Battery Removal And Installation - haupa AS-6 Instruction Manual

4. BATTERY REMOVAL AND INSTALLATION

4.1. Battery removal.
Hold the grip firmly and press the battery release button to remove it, as shown in the following figures.
CAUTION
Never short circuit the battery
1. Battery installation
Insert the battery ensuring that the poles are correct (see previous figures)
4.2. Battery charging.
Before using the tools, charge the battery as follows:
4.2.1. Plug the charger cable into an AC socket.
Once the charger plug has been connected to the mains, the red pilot light will light (At 1 second intervals).
4.2.2. Insert the battery in the charger.
Firmly insert the battery, in the direction indicated in the following figures, until it comes into contact with the
charger compartment bottom.
CAUTION
If the battery is inserted the wrong way round, apart from not charging this could also damage the charger, such as the deformation of the charging terminal.
4.3. Battery charging.
When you insert a battery into the charger, the battery will start to charge and the red pilot light will be on continuously.
Once the battery is completely charged, the red pilot light will flash (at one second intervals). See the following table:
4.3.1. Pilot lamp indications.
The following table shows the different pilot light indications according to the charger or battery status.
4