1. Technical data Area of application: For the creation of an electrical connection by means of compression Scope of delivery: 1 crimping tool, 1 charger, 1 battery, 1 carry loop, in plastic case, without pressing dies. Pressing force: 60 kN Oil type: ISO class viscosity 15 Safety:...
Page 3
Pushbutton to advance Thorn pressing Pushbutton for return movement … convincing solutions Germany: HAUPA GmbH & Co. KG, Königstraße 165-169, D - 42853 Remscheid. Phone: +49 (0)2191 8418-0, Fax: +49 (0)2191 8418-840, sales@haupa.com • Errors and technical changes reserved.
Page 4
3. Notes regarding correct use Before you start work, all active, thus current-carrying elements in the area around the assembler must be switched to without power. If this is not possible, protective procedures for working in the vicinity of components under current must be implemented. The charge status of the battery should be checked before you start work 3.1.
Page 5
Please remove the battery during transport and after usage – because of avoiding deep discharge! … convincing solutions Germany: HAUPA GmbH & Co. KG, Königstraße 165-169, D - 42853 Remscheid. Phone: +49 (0)2191 8418-0, Fax: +49 (0)2191 8418-840, sales@haupa.com • Errors and technical changes reserved.
Page 6
2 Ah 60 min. Permitted only on stabilized power sources! Charging only for HAUPA batteries!
WITH EVERY REPLACEMENT PART ORDER, INCLUDE THE FOLLOWING INFORMATION: 1) Article number. 2) Article description. 3) Reference to the operating instructions and/or date. 4) Tool type. 5) Serial number of the tool. The guarantee is voided if you use parts that are not original replacement parts from HAUPA.
216663/M; 216667; 216667/M; 216669; 216669/M Note: A correct connection according VDE 0220 Part 2 is only guaranteed if the user work with Haupa cable lugs and also adequate HAUPA pressing tools. The tools are not isolated and it is forbidden to work under tension.