Required Tools And Materials - Siemens SIMATIC NET RUGGEDCOM RSG2300 Installation Manual

Communication Ports
Port Status Indicator LEDs
Display Mode Indicator LEDs
Mode Button
Alarm Indicator LED
Power Module Indicator LEDs
RS-232 Console Port
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RSG2300:
AC power cord (16 AWG)
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #8-32 screws
RUGGEDCOM RSG2300
Installation Manual, 01/2020, C79000-G8976-1046-15
Ports for communicating with other devices or accessing the
RUGGEDCOM RUGGEDCOM RSG2300 operating system are de-
scribed in
Port status indicator LEDs indicate the operational status of each
port, dependent on the currently selected mode.
Status
Duplex
Speed
The display mode indicator LEDs indicate the current display mode
for the port status indicator LEDs (i.e. Status, Duplex or Speed).
The Mode button sets the display mode for the port status indicator
LEDs (i.e. Status, Duplex or Speed). It can also be used to reset the
device if held for 5 seconds.
The alarm indicator LED illuminates when an alarm condition exists.
The power module indicator LEDs indicate the status of the power
modules.
• Green – The power supply is supplying power
• Red – Power supply failure
• Off – No power supply is installed
The serial console port is for interfacing directly with the device and
accessing initial management functions. For information about con-
necting to the device via the serial console port, refer to
ing to the Device (Page
Tools/Materials
1.3 Required Tools and Materials
"Communication Ports (Page
Mode Color/State
Green (Solid)
Green (Blinking)
Off
Green
Orange
Off
Green (Solid)
Green (Blinking)
Orange (Solid)
Off
21)".
For connecting power to the device.
For connecting the device to the network.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Introduction
23)".
Description
Link detected
Link activity
No link detected
Full duplex mode
Half duplex mode
No link detected
100 Mbps
1000 Mbps
10 Mbps
No link detected
"Connect-
Purpose
3