Changing The Factory Defaults - Zhone SkyZhone 1600 Hardware Installation Manual

Changing the Factory Defaults

Refer to the SkyZhone CLI Reference Guide for a list of supported commands to configure
advanced SkyZhone features.
If you are not using the factory default VLANs, you need to delete the default VLANs and
configure the VLANs that are appropriate for your network.
In the example below, VLAN 2 is used for management. Also, VLAN 122 is the data VLAN
instead of VLAN 1.
1. Delete the default VLANS. The following commands remove the default VLANs:
2. Define the new management VLAN. In this example, VLAN 2 is the management VLAN.
3. Configure the management address. In this example, the device address is 10.108.14.218.
4. Define the data VLAN. In this example, the data VLAN is VLAN 122.
These commands create the following configuration:
/config vlan vlanconfig removeport interface eth1 vlanid 1
/config vlan vlanconfig removeport interface wlan0 vlanid 1
/config vlan vlanconfig removevlan vlanid 1
/config vlan vlanconfig addvlan vlan_name management vlanid 2
/config vlan vlanconfig addport interface eth1 vlanid 2 tagged
/config vlan portdefaults vlanport eth1 pvid 2 priority 1
/config if interface brvlan2 ip 10.108.14.218 mask 255.255.255.0
broadcast 10.108.14.255
/config if route-add destination default gw-addr 10.108.14.254
/config vlan vlanconfig addvlan vlan_name data vlanid 122
/config vlan vlanconfig addport interface wlan0 vlanid 122
untagged
/config vlan vlanconfig addport interface eth0 vlanid 122 tagged
/config admin-tools save running-config
VLAN Tag/Untagged
2 Untagged
122 Tagged
122 Untagged
Port
eth1(Ethernet)
eth1 (Ethernet)
wlan0
SkyZhone 1600, 1400, 1200 Hardware Installation Guide
IP address
10.108.14.218
41