Zhone SkyZhone 1600 Hardware Installation Manual page 4

Note:
•
The Skyzhone-1x00 products are shipped with a flexible 14' power cord with a NEMA-15, 3-wire
plug. An alternate 5' cord with NEMA-15, 3-wire plug can be ordered as well. Removal of the
product from the installation for return to factory for repair or maintenance can be accomplished by
disconnecting the AC power at the unit circular twist-lock connection
•
This equipment has been tested and found to comply with the limits for a Class C digital device,
pursuant to part 15, subpart C, of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the user manual, may increase the potential for harmful
interference to radio communications.
•
This warning applies to the Skyzhone-1400 and SkyZhone-1600 only. This equipment has been
tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which the
user will be required to correct the interference at their own expense.
•
The supplied cables and antennae must be used to ensure compliance with Part 15, FCC Rules.
The use of any other antennas will invalidate the unit's FCC Part 15 certification.
•
The 2.4 GHz band has been designed to operate with the antennae listed below, and having a
maximum gain of 5 dBi. Antennae not included in this list (Comet Part Number CFA-245W-SR) or
having a gain greater than 5 dBi are strictly prohibited for use with this device. The required
antenna impedance is 50 ohms.
•
The 4.9 GHz band has been designed to operate with the antennae listed below, and having a
maximum gain of 5.3 dBi. Antennae not included in this list (Comet Part Number SF-D49NW-SR) or
having a gain greater than 5.3 dBi are strictly prohibited for use with this device. The required
antenna impedance is 50 ohms
•
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropic radiated power (e.i.r.p.) is not more than that permitted for
successful communication. Operating the device with the supplied antennas will ensure that this
requirement is met.
•
Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
SkyZhone 1600, 1400, 1200 Hardware Install Guide
4