Zhone SkyZhone 1600 Hardware Installation Manual page 37

Figure 15: Base, Bracket, and Front Cover displaying two holes for antennas
8. Attach the antennas to the SkyZhone access point.
Note that the antennas are different sizes which are appropriate to the specific radios. The
three longer antennas are connected to the top of the unit. The two shorter antennas are
mounted to the bottom of the unit. The antennas are not interchangeable. It is critical that
the longer antennas are on the top, and the shorter ones on the bottom of the unit.
9. Slide the SkyZhone station onto the wall mounting bracket.
10. Secure the SkyZhone to the wall mounting bracket with the 4 (four) tamper-resistant screws,
provided in the installation kit, through the holes on the front of the unit.
WARNING!
conducting the next steps.
11. Attach the Ethernet cable.
12. Attach the AC power cable to the unit (other end connected to AC Mains by a licensed
electrician per local and national codes.
13. Attach the lid of the protective cover and secure it with the screws provided in the installation
kit. The final assembly appears in Figure 16, and the final installation appears in Figure 17.
Insure that the Chassis Ground is properly connected before
SkyZhone 1600, 1400, 1200 Hardware Installation Guide
37