Step 1: Connecting This Unit - Yamaha ProjectPhone PJP-100H Owner's Manual

Step 1: Connecting this unit

Follow the procedure below to connect this unit to the network, and then connect the AC adapter.
1
Using a LAN cable, connect the LAN port of
this unit to the network.
2
Connect the AC adapter to the DC IN 12V
terminal.
3
Connect the power cable to the AC adapter.
4
Connect the power cable to the AC outlet.
This unit is turned on and the microphone indicators
light up in sequence.
1
2
3
■ Standby mode
Pressing and holding
this unit to the standby mode. In the standby mode,
"STANDBY" is displayed on the screen of this unit.
To exit the standby mode and switch this
unit on again:
Press any key.
Preparation Procedure
4
To an AC wall outlet
(Disconnect) for 3 seconds sets
9