Yamaha ProjectPhone PJP-100H Owner's Manual page 15

■ Assigning the IP address manually
Follow the procedure below to register the network
information manually.
Note
Before setting the network information, check that this unit is
connected properly to the network. If the disconnected icon
(page 10) is displayed on the top right of the display, check the
LAN cable connection and the condition of the network to which
the LAN cable is connected.
y
The factory settings of the network information are as follows.
– IP address: 192.168.100.200
– Subnet mask: 255.255.255.0
– Default gateway: 0.0.0.0
/
1
Press repeatedly until the initial display
appears.
"???.???.???.???" is displayed if a DHCP server does
not exist in the network, and the IP address obtained
from a DHCP server is displayed if it is.
IP: ???.???.???.???
Menu :Address
2
3
Numeric keys
1 2 3
4 5 6
7 8 9
0
MIC MUTE VOL
/
4
Press .
The menu screen appears.
Menu
1. Settings
2. Call History
3. Online
Press or to select "1. Settings", and
then press .
The "Settings" menu appears.
Settings
1. Network Settings
2. Sound Settings
3. General Settings
Press or to select "1. Network Settings",
and then press .
The "Network Settings" menu appears.
Network Settings
1. DHCP
2. IP Address
3. Subnet Mask
Preparation Procedure
11