PorterA Handshower Holder The PorterA handshower holder is suitable for use with handshowers using hoses with conical nuts. Tools required Grease pencil or other marking device Drill with 6 mm bit suitable for wall surface phillips head screwdriver slot head screwdriver silicone sealant Installation Consideratons: The screws and anchors included with this set are suitable for use in tile or...
Page 3
Drill the holes. Install the anchors. Seal the wall around the anchors using a silicone sealant. Screw the mounting bracket into the top anchor only. Use the second screw to attach the PorterA holder through the mounting bracket to the bottom anchor.
Adjust the Tension It is possible to adjust how hard or how easy it is to change the angle of your PorterA handshower holder. Remove the cover (if necessary) by sliding it upwards. Use a slot-head screwdriver to turn the adjustment screw - clockwise to make movement easier, counter-clockwise to make it harder.