Advertisement
Porter’A Handshower Holder
Installation Consideratons:
The screws and anchors included with this set are suitable for use in tile or
other solid surface materials. They may not be suitable for all applica-
tions.
If you are installing this unit in a fiberglass or acrylic enclosure, please
contact the manufacturer of the enclosure for their recommendations
regarding reinforcement, mounting locations, and fasteners.
Save time and frustration: Before beginning installation, take a few
moments to thoroughly read these instructions. Inspect your Porter’A to
insure that all parts are present and in good condition. Make sure that
you have all tools and supplies necessary to complete the installation. If
you have any questions regarding the installation, please contact
Hansgrohe Technical Support.
Installation Instructions
Place the mounting bracket against the wall at
the desired location. Use a grease pencil or
other device to mark the locations for the
screw holes. Remove the mounting bracket to
a safe location. Do not drill through the
mounting bracket.
The Porter’A handshower holder is
suitable for use with handshowers
using hoses with conical nuts.
Tools required
Grease pencil or other marking
device
Drill with 6 mm bit suitable for wall
surface
phillips head screwdriver
slot head screwdriver
silicone sealant
Advertisement
